Re: Fix and Sale 72 GMC 3/4 ton 4x4 K2500
Here are a few picts of getting the trim lined up for placement and one of the the new carburetor from Summit, distributor cap, rotor, wires and plugs install. Found out the distributor had an Mallory Unilite electronic ignition installed....that's a plus!
Need to get the repaired heater core install this evening and while I have the fender dropped I will finally get some paint on it. Ordered some new trim clips for the upper and lower side for both the bedside and the front fender. Found a pair of good rear light trim bezels for back of bed that were missing. The repaired bedside will need holes drilled to accept the trim.
Also bought a set of 12" hubcaps and they will not fit, so I guess i will be looking for another set of GMC 4x4 12" caps. The front ones I could make the hole larger to fit over the hubs, the rears are not deep enough to fit of axle sticking out.
|