View Single Post
Old 06-15-2011, 04:08 PM   #18
jbclassix
Junk Yartist
 
jbclassix's Avatar
 
Join Date: Jul 2009
Location: Greeley, CO
Posts: 2,203
Re: NP 205 Rebuild and Info

I am stopped here for a bit, this is a picture of my rear output yoke. I am going to try to clean off the teeth marks and speedi-sleeve it. This would be why I had a bad leak at the rear output.



If all your yokes are good to go, The torque spec that I found is 150lbft for rear. The front of this case is 10 spine. I don't have a torque spec. 30 and 32 spline front output torque is 150lbft. I will be using new nuts on both and speedi-sleeves on both. Once I have the sleeves I will cover the repair here.
__________________
-Jeremy

YOU ONLY FAIL IF YOU STOP TRYING

70 Crew Cab Build Link

70 GMC Suburban 4X4 build thread

95 Yukon Daily Driver

Rebuilding an NP205

Last edited by jbclassix; 06-26-2013 at 12:43 AM.
jbclassix is offline   Reply With Quote