Re: My 50 roadster pickup build
This is all finished here, so I'll walk you thru it in steps. Here you can see that I added a 2"X2"X1/4" wall square tubing along the back of the door opening. This piece run from the top down inside the area of the inner cab corner, and will tie into the 3" plate you installed above. This pic also shows that I have removed my floor brace that the seat riser attached too. If you keep your brace you will have to trim it for the 2"X2" tubing to fit down inside the pocket.
Last edited by oldman3; 04-25-2011 at 10:07 PM.
Reason: spelling
|