[gottattooz]

I mounted the dash speakers. I used a hole saw just a little bigger than the magnet, plugged it in and secured it through the pad into the bottom plastic support of the dash pad. I also mounted the drl light sensor between the defrost vents.

I had to cut of the Mount tabs on the back of the wiper cowl grille because i had to weld up the holes. So I made new mounts to maintain the proper mounted height of the grille.

I squared the body up where I wanted it and I welded the cowl to cowl panel in permanently. We have a few tubes of Sikaflex sealant left over from building the garages, so I used it to seal the seams where I welded the covers. I thought the sealant was black, but it's very gray. I'll paint it black later.

-Josh