Quote:
Originally Posted by theastronaut
If you're already on 4" springs you'd probably want to go to dropped spindles next. You're just about at the point of running out of travel if you go any lower with springs. Do you have the bump stop brackets cut off already? If you just installed the springs then drive around on them a bit, some say they'll settle.
|
I have the rubber bump stops cut off but I have not removed the brackets yet. I have seen where some people cut the factory springs to lower it 5 1/2”.. that’s why I was thinking maybe I could cut half inch out of my 4” drop springs to get another inch out of it.. i think if I did that and removed my bump stop brackets I would have plenty of travel and not bottom out.
Posted via Mobile Device