The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

epfatboy · 01-13-2019, 04:39 PM

Looks easy enough to get almost 2"!

I already re-sized the intermidiate shaft and used 2 roll pins which will punch out easy. I also have a floor shift and tilt so this should be mint.

Feels like I can punch out the roll pins, remove the bolts to the dash bracket and push the Column in until the forward colum nut lines up with the back bracket bolt hole and bolt it up. Then I can redrill the steering shaft for new roll pins.

01-13-2019, 04:39 PM	#5
epfatboy Registered User Join Date: Mar 2018 Location: Barrington nh Posts: 101	Re: 1974 Sliding steering column forward Looks easy enough to get almost 2"! I already re-sized the intermidiate shaft and used 2 roll pins which will punch out easy. I also have a floor shift and tilt so this should be mint. Feels like I can punch out the roll pins, remove the bolts to the dash bracket and push the Column in until the forward colum nut lines up with the back bracket bolt hole and bolt it up. Then I can redrill the steering shaft for new roll pins. Last edited by epfatboy; 01-13-2019 at 07:01 PM.