Re: Tired of looking at it... for now..
i have forks on my jd 4500-slide the 2 forks together -take a piece of box or rect. or channel tubing &slide over the 2 forks {remember 2 forks are stronger than 1 } take a pivot cup -off the top of a floor jack & weld a piece of tubing to hold it on the tubing on the forks -this will give you a swivel -that you can lift the truck up by the rear axle & move it ! if worried about losing it put a small chain from truck r/end housing to the tractor -forks mask ? also i try to wedge this pivot mount on the forks -hope my description is not confusing ! good luck-truck looks good -keep on it -finish it!
Last edited by wahl4m; 11-19-2017 at 08:53 AM.
Reason: forgot some detail
|