The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

*YoungPup1977* · 05-20-2018, 01:33 PM

You do not have to remove the linkage to go any further into the trans...

Once you remove the snap ring from the front 5 pinion planet you should be able to pull the front planet, 3/4 clutch hub, sun shell, and sun gear out of the case...the output shaft will come out at this time.

You can pull the snap ring for the center support to check the sprag and the low and reverse clutches/steels.

watch for the anti clunk spring between the case and center support.....having fun !!!

05-20-2018, 01:33 PM	#4
YoungPup1977 Account Suspended Join Date: Jun 2015 Location: No longer here Posts: 1,000	Re: 4l60e/4l65e/4l70e 4WD to 2WD shaft swap You do not have to remove the linkage to go any further into the trans... Once you remove the snap ring from the front 5 pinion planet you should be able to pull the front planet, 3/4 clutch hub, sun shell, and sun gear out of the case...the output shaft will come out at this time. You can pull the snap ring for the center support to check the sprag and the low and reverse clutches/steels. watch for the anti clunk spring between the case and center support.....having fun !!!