The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project: "Might-as-well" - 70 C-10 LWB

Steve Hafner · 07-20-2011, 08:59 AM

After taking out the rubber floor covering, I discovered the driver's side floor had a good-sized hole in it and the passenger side floor had been badly patched - so, I took the truck to a local body shop to have these areas repaired PROPERLY. While that was being done, I took out the gauge cluster and replaced all of the bulbs and was going to install the new bezel I bought and I thought I "MIGHT-AS-WELL" have it gone through by a local gauge restorer. I bought a new, reproduction steering wheel for it around this time too. The last picture here shows why.

07-20-2011, 08:59 AM	#7
Steve Hafner Registered User Join Date: Sep 2010 Location: Northport, Alabama Posts: 1,353	Re: Project: "Might-as-well" - 70 C-10 LWB After taking out the rubber floor covering, I discovered the driver's side floor had a good-sized hole in it and the passenger side floor had been badly patched - so, I took the truck to a local body shop to have these areas repaired PROPERLY. While that was being done, I took out the gauge cluster and replaced all of the bulbs and was going to install the new bezel I bought and I thought I "MIGHT-AS-WELL" have it gone through by a local gauge restorer. I bought a new, reproduction steering wheel for it around this time too. The last picture here shows why. Attached Images Last edited by Steve Hafner; 08-22-2011 at 05:39 AM.