The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - converting a 90ohm sender to a 30ohm sender

**VetteVet** · 02-17-2011, 12:48 PM

I second that, if you recall one of the guys in Docvette's forum suggested running the resistor from the sending unit terminal to the ground flange on the sending unit. That's the same thing you have in the drawing, only a little further from the sending unit. Be sure and give us feedback on it. This one don't come up very often and it would be nice to have an answer. VV

02-17-2011, 12:48 PM	#17
VetteVet Msgt USAF Ret Join Date: Jan 2005 Location: Kalamazoo, Michigan Posts: 8,703	Re: converting a 90ohm sender to a 30ohm sender I second that, if you recall one of the guys in Docvette's forum suggested running the resistor from the sending unit terminal to the ground flange on the sending unit. That's the same thing you have in the drawing, only a little further from the sending unit. Be sure and give us feedback on it. This one don't come up very often and it would be nice to have an answer. VV __________________ VetteVet metallic green 67 stepside 74 corvette convertible 1965 Harley sportster 1995 Harley wide glide Growing old is hell, but it beats the alternative.