Re: Choosing a transmission crossmember
Ok guys, got it in. Had to also get a new mount, other one had bad threads.
Went in real smooth, minor trimming to fit. The center rotates in the end pieces, and I have not welded it just yet. I have a couple questions.
Where to place angle finder, each spot gave me different reading, or wouldn't real change when I jacked up or down. I put it on pan, on screws that hold pan, and on the very end on shaft.
Next, when I weld tube to keep from rotating any, I need to make sure the pad is parallel to mount surface on bottom of trans right?
|