Re: 700R4 build thread.
Valve Body...
It is very important your work area is clean, Any Valve or Valve Bushing needs to be cleaned as well as the Bore it is removed from. I use a Solvent Blow Gun & New Clean Solvent, Blowing Solvent is hazardous to your Lungs.
Always place your finger over the hole a Bushing/Valve is in when removing a Roll Pin, The 700 isn't to bad about this (The 3-2 Spring IS), Just a good habit.
Let's start with the MOST important part (And gives the most issues) The TV Valvetrain.
Remove the TV Plunger Bushing Roll Pin.
Remove Plunger & Bushing, Use the Plunger Valve as a slide hammer to remove the Bushing, Use fingers, Not Pliers, Dykes or any other tool if you plan on reusing the Plunger or Bushing. New "94 Code" Plunger assembly is a recommendation.
Remove TV Spring.
Remove TV Valve Roll Pin. See Pic.
Remove TV Valve.
|