The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project-GMC Slant Nose

Kabwe · 10-01-2012, 11:55 AM

Well I looked at your build after you bullied me.lol I like the project man its nice. As far as removing the bondo use a heat gun or propane torch with putty knife. I prefer the heat gun if you don't have one you can borrow mine. Now you are not trying to put a lot of heat into the panel, you are only heating it enough so that the bondo loses its adhesiveness. Also another method is air craft paint remover but it takes several applications and I don't like the mess or getting it on my skin which you will as you scrape it off. Let me know.

10-01-2012, 11:55 AM	#45
Kabwe Certified Car Nut Join Date: Jan 2005 Location: Inglewood, California Posts: 3,118	Re: Project-GMC Slant Nose Well I looked at your build after you bullied me.lol I like the project man its nice. As far as removing the bondo use a heat gun or propane torch with putty knife. I prefer the heat gun if you don't have one you can borrow mine. Now you are not trying to put a lot of heat into the panel, you are only heating it enough so that the bondo loses its adhesiveness. Also another method is air craft paint remover but it takes several applications and I don't like the mess or getting it on my skin which you will as you scrape it off. Let me know. Last edited by Kabwe; 10-04-2012 at 02:40 PM.