Posted RFmaster orginally:
http://67-72chevytrucks.com/vboard/s...d.php?t=515419
1. Install a jumper wire between Pins A & B of ALDL diagnostic connector.
2. Turn on the ignition (but don't start the engine)
3. Wait 30 seconds.
4. Leave ignition on and disconnect the IAC connector (four wire plug).
5. Remove the jumper wire from the ALDL connector.
6. Start the Engine. The engine probably will run rough and may stall. Just restart and try again.
7. Adjust the throttle stop screw to set the idle to 500 RPM +/- 50 RPM. - stock camshaft!
8. Turn the engine off and reconnect the IAC connector.
9. Turn ignition on and adjust TPS to proper settings. (0.60 - 0.65Vdc at idle is typical, but 0.3 to 0.9Vdc will work)
10. Repeat procedure until the 500 RPM +/- 50 RPM (stock cam) in step 7 can be maintained while TPS is at proper idle setting. Performance camshaft may require higher idle RPM!