[westofb]

I have access to a 1/2 ton for parts, was planning on using it to complete the swap. Just looking the lower arms appear to be the same, so thanks KOOL IT, I now know they are not. Okay so I can change the lowers out too, I already have a set of 1/2 t dropped spindles, so am planning to use them for the swap...I now need to know about the tierod ends, will the 3/4's fit the 1/2 t spindle? If not are the threaded ends where they attach to the adjusting sleaves? Everyone has been so helpful, gotta keep going back to the well for more.

Okay somebody else chime in and rain on my parade....j/k, thanks for the help guys!