[Jeramy]

so after tearing the engine down and checking everything it was all within spec so i deglazed the cylinders, scrubbed down and degreased the block, and put it back together with new rings and bearings. im going to run the swirl port heads for now since i already have a carb intake to fit them.

hopefully next weekend i will have time to degrease the heads and put in new vavle guide seals along with lapping the valves.

i didn't take any pictures because i figure everyone has seen a black 350 short block before lol.

as a disclaimer i am not building this motor as a permanent replacement for my truck. The 305 in my truck is dieing fast so im trying to throw together a decent stockish 350 with out cutting to many corners to run for the next year or so.