|
Re: C4 Dropmember and Trailing Arm Conversion Install
Quote:
Originally Posted by SCOTI
Bolt hole alignment of the CPP piece vs. an OE c.member where it bolts to the frame similar? You have PM.....
|
Took some measurements, I can move the x-member back about 1.75" and forward maybe an inch. My install was about 1.5" forward of where CPP had placed their x-member on their '79 build. The rear cab mount and the cab floor are the two limiters. See pictures.
Kind of hard to see but the cab floor does go below the frame/x-member.
Here is the rear of the x-member and the rear cab mount.
__________________
83 C10 Stepside (SOLD, it was a blast!)
383 MASS-FLO EFI/TKO II 600/3.90 Posi 10 bolt
S475 and C4 DM running, fine tuning
turbo= 
Douchebag Racing: Runs Fine all the Time
|