Quote:
Originally Posted by FAKKY
If I wanted to change the bushings ....with the brass ones in kit
Would a HF bearing driver kit and a press do most of them ?
Just debating on forking out $140 on press and $40 on drivers to have one and use for this job. Then be useful for others.
You like any clutch over another for 3-4.
|
No need to buy a press, the bushings do not require a press to install them...people who use a press to install bushings most likely break things. The case bushing, the sun gear bushing (sonnax wide bushing) and pump bushing needs replaced, those are the most critical ones, so start there. the Stator bushings that fit onto the input shaft should be OK to use, but check them anyways.
I use red eagle clutches in my builds but you can use others if you like. not required...