Re: Transfer case torque mount
attached are some images of the torque mount and adapter mount.
I glued the adapter rubber mounts to the crossmember and filled in any air gaps or spaced. the current after market tranny mounts are a sloppy loose fit all around but work when the weight is fully on them. but there are two steel sleaves or tubular bushings that slid up into those mounts. There is alot of airspace and gaps around what should be normally very well supported. I filled it all in with the RTV sealant caulking.
I got the sealant at Ace. for 4.99 vs about 1 fifth that amount from NAPA for 8 bucks.
glued it all together, snugged up the fasteners and let it vucanise for 24 hours.
when its all dry I trim off the exess with a razor.
the t case adapter rubber mounts were brand new . the t case torque rubber bushings were origonal and in good shape. I cleaned them off with GOJO type hand cleaner. Its very forgiving and does not rot them like petroleum based cleaners do. protects and softens and they shine like new.
I hope the pictures help. especially with missing parts and correct reassembly.
|