The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Removing window crank & inner door handle

PanelDeland · 11-11-2006, 10:30 PM

I built a clip puller.I used a welding rod and flattened one end,then bent the end about an 1/8th of an inch.Works pretty good for a quickie.Actually went to the parts store to get a tool and they were out.I still want to get the tool since it works well on the door panels in rides with the plastic retainer cllips.

11-11-2006, 10:30 PM	#7
PanelDeland I am a Referee of life. Join Date: Jun 2000 Location: Greensboro N.C. Posts: 13,993	Re: Removing window crank & inner door handle I built a clip puller.I used a welding rod and flattened one end,then bent the end about an 1/8th of an inch.Works pretty good for a quickie.Actually went to the parts store to get a tool and they were out.I still want to get the tool since it works well on the door panels in rides with the plastic retainer cllips. __________________ The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil"