Quote:
Originally Posted by jackyl9999
I am not going to be able to swap out the 1157 due to my led tail lights being wired in to my harness. (Repop taillight buckets)
I have some resistors left over from my swap. I used them for my tach to cut out some electrical noise.
http://lt1swap.com/lsx_tach.htm
Would they work?
Also does this need to be one side or both tail lights? |
Yep, 1K ohm will work fine. I'd feel better about the safety factor with a 1/2 watt, but a 1/4 watt should work as well. You only need a single resistor from the brake signal wire to ground. It won't buy you anything to put one at each tail light.