[gottattooz]

I went to the junkyard today, looking to find some missing pieces for the truck. I picked up a duel filler neck out of a 1990 Nissan Maxima. It's 1 1/4 inch, just like the neck on the poly tank. I wanted to mount the filler neck inside the bed, but not on the floor. I cut the filler neck about 3 inched below the top bracket, then cut a hole on the inside of the driver's bed side, just in front of the rear stake pocket. I couldn't find and 1 1/4 pipe with a sharp enough bend to cut under the floor panel toward the fill neck on the tank. I ended up going to Tractor Supply and getting a 1 inch 90 degree elbow, and a 12 inch threaded 1 inch pipe. The outer diameter of the 1 inch pipe is 1 1/4 inches. I cut a length of 1 1/4 hose to connect the filler neck to the pipe elbow, then secured both ends. I haven't put the bed back on, because I need to get a fitting for the vent tube on the tank, and I get those free at work, so it'll have to wait until Monday.

-Josh