View Single Post
Old 01-05-2017, 12:37 PM   #6
Registered User
Join Date: May 2013
Location: Yuma, Az
Posts: 19
Re: Correct inner spindle seals

I did not remove any small v rubber seal. And I did not remove a larger V rubber seal. The NAPA kit has the small rubber seal and the larger rubber seal. Seems that if the needle bearing only goes in so far, that there would be a shim or washer to prevent from pressing in further that it should go. Was told by a tech from a 4x4 site that the metal/rubber seal pressed in place should eliminate the need for the small and large V rubbers. Hoping to get another opinion.
tewels is offline   Reply With Quote