View Single Post
Old 01-05-2017, 03:00 PM   #11
kwmech
Senior Member
 
Join Date: Mar 2003
Location: Colfax-California
Posts: 5,249
Re: Correct inner spindle seals

Bearing way too deep. Yes the rubber V should be slightly proud of the spindle face, just enough for a small press or squeeze. I always eyeball it. Course I've done hundreds of them. Before you reassemble, pack that bearing with a good dollop of grease and put the same grease on the V seal and the plastic thrust washer, and also the larger rubber dust seal where it is going to spin on the back of the spindle
kwmech is offline   Reply With Quote