Re: Trying to make Junky perhaps just a little bit Funky...
I have made a little more progress in removing the old floor pan. I drilled out all of the spot welds in the back of the cab, and removed the rocker panel from the drivers side of the cab. I suppose it's a good thing whoever installed the rocker panel did a crappy job; it made it a bit easier to get it off. I left a small piece on at the front of the cab as I was afraid of cutting possible good metal below it. Turns out I did not have much to worry about. Now I need to decide whether to repair the inner cowl and the pillar before or after I replace the floor board. Seems to me like it might make more sense to try and do it afterwards.
|