The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Replacing mid shaft bearing on driveshaft...need a little help

**Wrenchbender Ret** · 12-11-2018, 12:53 PM

It is right hand threads but it usually is tight & a hard place to get to. I have a ground down wrench I have used on them. Sometimes you have to disassemble the U-joint to get to it.

12-11-2018, 12:53 PM	#3
Wrenchbender Ret Registered User Join Date: Oct 2005 Location: Overland Park, Ks. Posts: 5,190	Re: Replacing mid shaft bearing on driveshaft...need a little help It is right hand threads but it usually is tight & a hard place to get to. I have a ground down wrench I have used on them. Sometimes you have to disassemble the U-joint to get to it.