[MP&C]

As the car is still apart and I wanted to use SPI epoxy to match/adhere well to what was already there, we went high tech with some modified paint rollers to address the rocker panels that were accessible from the back side. rotisserie was used to direct paint flow and epoxy filled between flanges well. Or as least I could tell it ran through...

Next, to use our fancy dancy paint rollers, getting epoxy inside the rocker panels and inner quarter in prep for installing the wheel wells... Had some SPI epoxy mixed up, poured a small amount in the inner quarter and used the long narrow roller to push paint all the way to the front of the rocker. Lather, rinse, repeat.









...and used a brush to cover the bare metal that was above the quarter panel's baffle..



There was a bit of overflow, or dust control shall we say.



One rocker down, one to go..