Thread
:
Anyone using Speed Engineering Headers???
View Single Post
01-08-2018, 01:57 AM
#
75
Project1970
14.1 @ 96MPH
Join Date: Jul 2001
Location: Mesa, AZ
Posts: 2,811
Re: Anyone using Speed Engineering Headers???
Photo dump of my Speed Engineering 1-7/8" long tubes:
Driver's side:
Passenger side:
The starter / O2 sensor wiring is tight as hell on the passenger side. At the very least I need to undo some of the terminals on the starter and re-orient the ring terminals. Definitely going to add some heat shielding over here.
Underneath:
The collectors aim pretty squarely at the trans crossmember. The exhaust shop is going to have to fab up a jog down here - the previous setup just had long downpipes that brought the whole system to below-frame level.
Clearance to the oil pressure sender is close but nothing to worry about.
I need to finish getting them installed (need new header bolts, ordered a set of studs for it) but I'm extremely happy with these for the money. They fit way better than the fourthgen shorty headers I've been running.
__________________
Project1970 - LS1 Swap Complete!
Project1970
View Public Profile
Visit Project1970's homepage!
Find More Posts by Project1970