Been working on it, and actually getting lots done, just not taking tons of pics
Rear bag mounts needed to be modified to work, installed and ready to go
All of the air lines are run, sensor lines are routed, and main power wire hooked up for the compressors.
Installed the rear Accuair sensors, fronts we are working on now
Just did some L-brackets to make them work
And my buddy Gary is still working on the floor, and the new cab support, the replacement panels are a little off, typical over seas made ****, some massaging to work.
But we should have the one side done shortly, and then get the driver side done right after it.
We are pretty well ready to drop the engine/trans in within a week now, just have to finish up the front sensors and go from there