[Rude Dude]

Good job after you get welded don't forget to it balanced at a driveline shop, I would run it first if you don't get a vibration over 75 then it won't need it.

Originally Posted by Madd Doc

Got some more work done today, since I shortened the wheel base I needed to shorten the drive shaft, so I just went for it. Cut the weld holding the end on and knocked it off with a hammer. (I did make an index mark before removal), using a hose clamp I marked off the 9" I was removing and cut it with the sawzall. Re insert the end and make sure the index mark was lined up, weld it up and dress it with a sanding disc. came out nice now I have to clean up the rest of it and paint it.