[testerdahl]

After reading a bunch of forum posts and taking a break for a while, I think I finally found the culprit - a bad wire.

Here’s why I suspect it. I made a hot switch setup with some wires and noticed I had nothing still. I then worked back to the starter.

I connected a jumper cable from the switched side of the starter and touched the to the positive battery post. The starter spun! I then cut the wire running to the ignition switch and did the same trick. Nothing, nada. It has to either be that wire or the way the end is connected to the starter.

There is a snow storm moving in and the next chance I get, I’m rewiring that connection to the switch.