|
Re: Making a G20 a 4x4???
Quote:
Originally Posted by bikes&bowties
wont the shifter on that 3 speed be 2-3 feet to far back......
i'd find a divorced np205 to go behind the transmission in there now.. fab up a crossmember (current thread in the 4x4 section) and get yours drive lines made.... just swap the rear axle with possibly some custom lift springs and then do something like a b52 kit on the front....
|
If you took the bend out of the shifter or even turned it 180 degrees in the case and reshaped it a little I bet it would work. I think the shifter boss would end up right about where the front edge of your seat is so probably a forward bent shifter would be needed.
You would need to find and adapt a hydraulic clutch setup for sure though.
__________________
miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was http://67-72chevytrucks.com/vboard/s...d.php?t=795577
69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been
69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc
68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E
79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars
|