[jojo-munson]

Hi all, my first post here! This site has been invaluable as I've been getting my grandpas 72 C20 350 going again after it sat for 10 years.

The truck has been blowing more and more white smoke every time I run her, even if she's already warm, and I'm loosing coolant. So I figured I'd take the heads off and replace all the gaskets.

But just my luck, a single bolt sheared off as I was unbolting the exhaust manifold on the drivers side. Lucky me it's the third from the front, so not terrible. But due to the inner fender and steering column I can't get my drill in there to use an easy out.

Any suggestions? Or am I going to have to bite the bullet and buy a right angle drill?