|
Re: 52 Project
I went down to dad's today for a couple hours and got the cab mount in on the pass side. Here is some pictures in a step by step form...might be boring but I wanted to show the steps that I did so if someone else is going to do this then it might make sense.
The first thing I did was to grind the mating surface to make sure that is was flat. Then I used weld through primer on that surface of the cab mount.
I then went to the cab and ground the area where the mount was going and prime that area also.
The third picture shows the spacer washers that I used to space the mount up off the frame.
Picture 4 and 5 shows the mount clamped to the frame and the rocker panel.
|