The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

*YoungPup1977* · 07-30-2019, 07:58 PM

When did you notice the stud pulled out of the head ?
Was this during the break in I am guessing... with all the port matching time spent on the heads, the screw in studs may have been a activity to perform but that's a after thought.. glad you found the stud pulled up out of the head and not the camshaft going flat.... That rocker noise must of got some ones attention

Got any pics of the stud pulled up and the screw in studs installed, any guide plates being considered ? Did your screw in studs go into the water jacket of the head ? How was the screw in studs installed ?

07-30-2019, 07:58 PM	#91
YoungPup1977 Account Suspended Join Date: Jun 2015 Location: No longer here Posts: 1,000	Re: Building my 283 When did you notice the stud pulled out of the head ? Was this during the break in I am guessing... with all the port matching time spent on the heads, the screw in studs may have been a activity to perform but that's a after thought.. glad you found the stud pulled up out of the head and not the camshaft going flat.... That rocker noise must of got some ones attention Got any pics of the stud pulled up and the screw in studs installed, any guide plates being considered ? Did your screw in studs go into the water jacket of the head ? How was the screw in studs installed ? Last edited by YoungPup1977; 08-01-2019 at 04:58 PM.