[Kennuck]

I know you are trying to save money by using the TH350 but your going to need a few things to use it. The engine needs a speed signal to operate properly so you are going to have to buy an electronic speed sensor to make it work. Guys will tell you, you can do away with the speed sensor but this generally results in poor fuel economy and driveability problems. I know there are also spacing differences between the torque converter and flex plate that may cause you problems?

Often you can buy an engine and trans combo for little extra than the engine alone and save all these hassles and gain overdrive. The 4L60E uses the same output shaft spline as the TH350 and with proper engine placement you can use your stock driveshaft. The total cost is likely a wash and you gain O.D.