View Single Post
Old 09-15-2014, 09:20 PM   #114
clinebarger
Senior Member
 
Join Date: May 2009
Location: Fort Worth, TX
Posts: 6,370
Re: 700R4 build thread.

Valve Body Gaskets, Separator plate, 2nd Accumulator, Aux Valve Body.

Use '88 & up Auxiliary VB gaskets with TransGo 700-P Plate ONLY, Even if your running a early Non-Aux trans, The Late gaskets fit the Plate better.

The Aux. Gaskets are identified by painted stripes in the Gaskets. And the Aux. VB holes

Recheck that the Case Checkballs are in place & correct.

With the 2 home made alignment dowels threaded in the "Z" holes.

Place The CASE gasket on the Case, The Gasket is identified by the letter C cut into the gasket.

Place the Separator Plate on the Case Gasket.

Place the Valve Body Gasket on the Separator Plate, Identified by the letter V cut into the Gasket.

Place the 2nd Accumulator Assembly on top & Start the bolts.

Place the Auxiliary Valve Body on top as well (Install #12 CheckBall on the plate or TransJel it to the Aux. VB), See post above for Checkball location.
Start the Aux. VB to Case bolts.
Attached Images
 
clinebarger is offline   Reply With Quote