View Single Post
Old 08-02-2017, 06:39 PM   #29
uxdesigner
Active Member
 
Join Date: Nov 2013
Location: Rocklin, CA
Posts: 187
Re: UXDesigner's 1967 C10 - The Keeper

Radiator installed, all lines tested for leaks with success. I originally thought about using the factory intake / box but it didn't look as clean as I had imagine and the fabrication to make it sit properly would be significant. I scrapped the idea and decided to go with an aftermarket SPECTRE 9900 Cold Air Intake System for ease of installation and I think the chrome gives the engine compartment a nice touch.





Also started drilling all the holes for the trim, took a lot longer than I thought but the pieces were great quality and fitment only needed a few tweaks.




Managed to get the front grill in epoxy and 2k to test gun settings and pressure as I prepare to paint in the next few weeks.


Last edited by uxdesigner; 10-11-2017 at 07:37 PM.
uxdesigner is offline   Reply With Quote