A while ago I agreed to put some stripes on the "blower box" lid for Rian's truck. Now before you read on I have to point out that I'm no expert pin-striper, but it is something I enjoy doing but I'm along way off the standard of the pros we all marvel at.
I collected the lid when we were all at the Supernats early August. Rian had blasted and painted it for me, unfortunately the primer Rian had used had reacted a little so rather than take any chances I stripped it back to bare metal, then etch-primed it followed by a good old coat of 2K black.
I asked Rian if he had anything in mind design wise and he said could I do a growling grizzly bear? I made a stencil and this was also put on in 2K as you can flat it right out and polish it smooth
Next I marked out the outside border for the design, with it being under the hood I wanted a heavy (ish) line so it would be visible from a distance
