View Single Post
Old 07-31-2014, 08:14 PM   #50
clinebarger
Senior Member
 
Join Date: May 2009
Location: Fort Worth, TX
Posts: 6,370
Re: 700R4 build thread.

Finally time to disassemble the Input Drum.

Hole saw a hole in your work bench to stick the Input shaft through so you can work on the drum.

Start with removing the 3-4 snap ring from the Drum, Grab the Apply plate at the bottom of the 3-4 stack, Stack upside down out of the way with the 5 Release springs that fall out of the drum & Snap ring.

Remove the Forward Clutch Snap ring (This snap ring is Stout).
Turn the drum over & The Forward Clutch stack, Forward Sprag Assembly, Overrun Clutches, & Sprag Torrington bearing will fall out of the drum.
Attached Images
   
clinebarger is offline   Reply With Quote