The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jbclassix · 06-14-2011, 11:32 PM

First I removed my rear output yoke. This is my home-made yoke holding fixture that has come in VERY handy over the years!

With the t-case in 4-hi I also removed the front yoke while holding the rear yoke.

Remove the speedo drive assembly

Remove the rear seal housing

The rear output bearing just slides off. It is "sandwiched between the yoke and speedo gear

Remove the speedo drive gear

Remove the spacer from behind the speedo gear

Remove the rear bearing housing. Be careful removing the housing, the front bearing is a needle type and they will fall out.

06-14-2011, 11:32 PM	#2
jbclassix Junk Yartist Join Date: Jul 2009 Location: Greeley, CO Posts: 2,203	Re: NP 205 Rebuild and Info First I removed my rear output yoke. This is my home-made yoke holding fixture that has come in VERY handy over the years! With the t-case in 4-hi I also removed the front yoke while holding the rear yoke. Remove the speedo drive assembly Remove the rear seal housing The rear output bearing just slides off. It is "sandwiched between the yoke and speedo gear Remove the speedo drive gear Remove the spacer from behind the speedo gear Remove the rear bearing housing. Be careful removing the housing, the front bearing is a needle type and they will fall out. __________________ -Jeremy YOU ONLY FAIL IF YOU STOP TRYING 70 Crew Cab Build Link 70 GMC Suburban 4X4 build thread 95 Yukon Daily Driver Rebuilding an NP205