View Single Post
Old 08-07-2014, 08:07 PM   #58
clinebarger
Senior Member
 
Join Date: May 2009
Location: Fort Worth, TX
Posts: 6,370
Re: 700R4 build thread.

ASSEMBLY.

If you did not install Case Bushing already, Do it now.

Install the transmission (low and reverse clutch outer, center, inner) seals (696) on the low and reverse clutch piston (695).
Lubricate the seals with Transjel or an equivalent.
Install the low and reverse clutch piston (695) into the case. The notch in the piston must be aligned with the parking brake pawl window, in the case.
Install the low and reverse clutch spring assembly (694).
Using the J23327-1 or similar tool, compress the low and reverse clutch spring assembly (694).
Install the low and reverse clutch retainer ring (693).

I don't use snap ring pliers on this snap ring, Using 2 long flat screwdrivers. Start one end of the snap ring in the groove using 1 of the screwdrivers, hold it in the groove, Use the other screwdriver to roll the rest of the snap ring in.
Attached Images
   
clinebarger is offline   Reply With Quote