Thread: HEI Conversion
View Single Post
Old 05-15-2017, 09:04 AM   #18
Sweeet67
Registered User
 
Join Date: Aug 2016
Location: Idaho Falls, ID
Posts: 232
Re: HEI Conversion

I just finished converting mr k10 to HEI. It is a tight fit but it's in without bending anything. It runs so much nicer now. I love it!
I also cut open the wire loom over to the firewall block and removed the inline resistor. I installed a whole new wire on to the factory connector. Not too big of a deal, just retaped it and put it back into the loom holder over the top of the firewall.
If you do a quick search, there is a pictorial thread of how to do it.
Sweeet67 is offline   Reply With Quote