View Single Post
Old 06-08-2017, 11:45 AM   #136
slow4dr
Registered User
 
slow4dr's Avatar
 
Join Date: Mar 2011
Location: SoCal
Posts: 151
Re: TCI to start new R&D Project with a C10!

Worked on the rear boxing plates. I removed the standard bolt-on frame plate that comes with the Torque Arm kit and placed it on top of the rail. I don't need to step the rails that far to get the desired ride height but it was a good starting point.

The frame is countoured in this area so I will have to put two bends in the new boxing plate to match the frame. R&D is really busy right now so I might not wait for them to draw these up and cut them on the plasma table. I might just trace and cut them out with the hand held plasma. Sure it's dirty but I am trying to get this thing back to a roller by the Brothers Truck Show.



slow4dr is offline   Reply With Quote