Got some cool(errr hot) parts ordered this week.
No picture tease yet but parts are on the way. Getting real close to engine/tranny mock up.
The frame is absolutely ugly right now but the fitment is pretty darn good. Had to section the top and bottom(note the cut) in order to pull the outer wall of the frame into the step. Still have to clean it up before laying down a bead.
I wanted to add a little extra bracing inside the frame rail where the front shock mounts. It's a just a piece of 1x2.120w tubing
Started working on the front boxing plates. I cut the driver side with the handheld plasma like I did the rears. Once it fit I used that as the tamplate for the passenger side. There will be a filler plate added to the top of the rail to close the gap.