|
Re: 3 spd shift linkages??
Quote:
Originally Posted by Dragcamaro
Would pics of a 1970 250/3 spd column Saginaw setup help for pics?
If so I can try to climb under mine tonight if the snow is melted enough.... my truck is unmolested to my knowledge so should be setup as from factory.
|
Yes, I think it would be helpful with it's application mentioned. Once this issue with this truck is solved this thread could be helpful for all the 3spd linkage questions.
Quote:
Originally Posted by '69 Gmc
Well... I went back to the donor truck today. The motor/trans is in the rear location. Explains the rods too long. I got another rod from him. Got home and it hits the clutch rod. Now I know what I need who’s got one??
Posted via Mobile Device
|
If you see what you need in my picture I'll let it go.
Quote:
Originally Posted by NewBayColony
Attachment 1885992
Finally got them to upload. I had to resize them.
What I'm looking for is one that is around 1" longer on the 2/3 arm (bottom-shorter 24" arm) and one that is 4" shorter than the top 29"1/R arm.
So in other words I'm looking for a 25" with a hook and a 25" straight piece. These are approximate numbers. Anything close, I would buy.
So, Special K, to bother you again, could you measure what you have? Thanks a ton for doing what you have done already.
|
Yeah, I'll do that today.
__________________
"BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed"
GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project)
GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling)
Tim
"Don't call me a redneck. I'm a rough cut country gentleman"
R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~
|