The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Run Away · 09-25-2016, 05:57 PM

Welded the drivers side wing up and primed while it was mocked into place.

The passenger side wing had rot too.

All welded

Back side

Ground

Primed. I made the upper hole where the dash bolts through too big, but it looks nicer than the ugly square I had before. It's all going to be hidden up under the dash anyways...

09-25-2016, 05:57 PM	#62
Run Away Registered User Join Date: Feb 2009 Location: Winnipeg, Manitoba Posts: 68	Re: Run Away's '69 C10 LWB Project Log Welded the drivers side wing up and primed while it was mocked into place. The passenger side wing had rot too. All welded Back side Ground Primed. I made the upper hole where the dash bolts through too big, but it looks nicer than the ugly square I had before. It's all going to be hidden up under the dash anyways...