[robs71k5]

Sorry guys I took a well deserved fishing holiday but am back now .So What I seem to be observing is some slackness at each side .I hope the Header was installed completely before the softopper . The rivets I sent were intended to be used in the snaps butI think they are too long and might have to be trimmed down .You can do this by punching out the rivet stem ,cut the rivet portion down and insert it back into the centre of the rivet hole Then install the rivet if rom the underside of the header to protrude thought the snap on the outer side .Hope that makes some sense
David did you install the header and have it bolted down before you installed the snaps across the front of the Header? That is paramount to getting a good product installation. The header needs to be installed so the pads at each of the four bolt down spots are mating together
Posted via Mobile Device