[Port&PolishMan]

You'd the Man
I understand all Your Input . - I'm stuck with a Two Pc. Drive Shaft - Unfortunately .

Also the Tail Stock on Truck Drive-Line is Not Centered - Neither is Pinion on Rear Gear.

But , from what I'm seeing so Far on this Truck - I can only Hope !
Hence the ?'s - Before I Go and Investigate Deeper .

Thank You - I have just started to set up , some Measuring Equipment .
Currently the Rear Bolt Mounts to the Trans - Are Not Even Bolted Down
NOT SURE - what those Intentions Could Be , so Digging In !