The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Building a Custom GMC Dash Bezel from the ground up :).

siggyfreud · 08-19-2015, 01:56 PM

Are the tabs that hold the bezel in threaded, or is it supposed to fit via the taper wedging it in, and pins through the 4 tabs not letting it come out? If it was threaded it would be a lot easier, as the bolts could hold it in place, and the taper wouldn't have to be exact fit. Looks like I see nuts on them, so that might work . . .

I'm going to test fit tonight, and will try and do 2-sided milling to get some taper in there tomorrow or Friday.

08-19-2015, 01:56 PM	#28
siggyfreud Registered User Join Date: Jun 2012 Location: Portland Posts: 1,330	Re: Building a Custom GMC Dash Bezel from the ground up :). Are the tabs that hold the bezel in threaded, or is it supposed to fit via the taper wedging it in, and pins through the 4 tabs not letting it come out? If it was threaded it would be a lot easier, as the bolts could hold it in place, and the taper wouldn't have to be exact fit. Looks like I see nuts on them, so that might work . . . I'm going to test fit tonight, and will try and do 2-sided milling to get some taper in there tomorrow or Friday. __________________ Current Build - Project "Ghost of Poseidon" 72 C10 Pro-touring build Previous Build - 66 GMC Pro-touring build. Sold.